Rosslare AC-G43 Especificaciones descargar pdf (Pagina 14)

Installation

14 AC-F/G4x Family Installation and Programming Manual

3. Installation

Installation of an RFID reader adjacent to metallic surfaces

might alter the reader’s specifications. To diminish this

interference, use a plastic spacer when mounting the reader.

3.1 Mounting Instructions

Prior to starting, select the location where the controller unit is to be

mounted.

To install the controller:

1. Open the controller by loosening and removing the case security

screw at the bottom using the security spline key.

2. Depending on the type of installation, gang box or panel mount,

drill the respective holes in the rear cover (Figure 3).

Figure 3: Drilling Holes Identification

The central hole is for routing the wiring to the controller.

3. Use the provided drilling template to accurately locate and drill

the required holes in the wall or panel.

4. Use the hardware provided to mount the back plate on the wall

or on a gang box. Be sure to route the wiring via the large center

hole in the back plate. Check for level.

5. Wire the controller's pre-wired cable as described in Section 3.2.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 51 52

Sin comentarios

Rosslare AC-G43 Especificaciones Pagina 14