Rosslare AC-215 Guía de instalación descargar pdf (Pagina 15)

AC-215 Single and Double Door Access Control Unit

Hardware Installation Guide

Tamper

The Tamper input connects to a tamper micro switch assembled within the ACU panel. The

following should be defined:

Single door controller:

Door 1 – IN2

Tamper input is activated when the panel is opened through vandalism. The system has two

additional tamper inputs on the reader terminals.

General

The General input connect to any general-purpose dry contact input.

Single door controller:

Door 1 – IN2A

This function can be used when activating the general-purpose output connections (for

example, alarm sensors, monitoring power supply failure, etc.). The ACU reports activation if

this input changes status.

The system has four output relays. Their contacts are voltage free and rated 5A at 12V AC or

DC. This indicates that output is very versatile and can operate virtually any electrical

equipment including Fail Open and Fail Close locks, electric gates and so on.

Outputs

We recommend using a suppression diode for all outputs.

Door Lock

There are two types of door locking devices:

! Fail open (fail secure)

! Fail close (fail safe)

! The user can select either normally open or normally closed output contacts.

The following should be defined:

Single door controller:

Door 1 – OUT1

Double door controller:

Door 1 – OUT1

Door 2 – OUT2

The output can sink current from any power supply (see page 28). In a time zone door locking

is activated in the following modes:

Grant Access

! Automatic Relock

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 38 39

Sin comentarios

Rosslare AC-215 Guía de instalación Pagina 15