Rosslare AC-215 Manual de instalación descargar pdf (Pagina 31)

Communications

AC-215IP Hardware Installation Manual 31

6. Communications

Communication lines are used to upload and download information between

the access control panel and the AxTraxNG™ software. When the access

control panel and the computer are communicating, the system’s two LEDs

flash accordingly.

 The RX LED flashes when the controller receives data

 The TX LED flashes when the controller transmits data

The access control panel address is defined in the AxTraxNG™ software.

It is important that the DIP switch and the software are set to the same

address.

There are three connection modes:

 Serial Network (RS-232 or RS-485)

 Modem Network

 TCP/IP Network

6.1 Serial Network Connection

The computer serial port controlling the access control panel is set from within

the AxTraxNG™ software. The default is 9600 bps for direct connection to the

computer.

When using an RS-232 connector, only one access control panel can be linked

to each communication port on the computer. Use an RS-485 if you wish to

connect more than one panel on one communication port.

The J1 switch must be in the correct position to select the RS-232

communication.

6.1.1 RS-232 Connection to the Computer

Set the J1 switch to the RS-232 position.

Table 6: RS-232 Connection

Access Control Panel DB9 Connector DB25 Connector

GND Pin 5 Pin 7

Tx Pin 2 Pin 3

Rx Pin 3 Pin 2

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 37 38

Sin comentarios

Rosslare AC-215 Manual de instalación Pagina 31