Rosslare AC-020 Manual de instalación descargar pdf (Pagina 12)

Testing the Reader

Swipe Family Readers Installation Manual Page 12

7 Testing the Reader

After wiring the Reader to the Controller and to a power

supply, test the Reader.

To test the Reader:

1. Power up the Reader. 3 long beeps are generated, and all

3 LEDs flash simultaneously for 3 seconds. After 30 seconds,

the LEDs illuminate alternately, from top to bottom.

2. Present the appropriate type of card to the Reader. If the

card is valid and contains a fingerprint template, a short

confirmation beep is generated, and all 3 LEDs will flash

indicating successful read.

3. Following the confirmation, the LEDs will turn on and off in a

fast circular mode, swipe your finger on the swipe sensor. If

the fingerprint matches the template on the card, three

short confirmation beeps are generated, and all 3 LEDs will

flash indicating successful read. If there is a mismatch, a

long, low beep is generated and the LEDs will turn off for

750mS.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Sin comentarios

Rosslare AC-020 Manual de instalación Pagina 12